MS4120F1006 : Honeywell Damper Actuator Spring Return, Fast-Acting, Two-Position, 175 in-lb (20 Nm), 120 VAC, for Fire and Smoke Dampers
SKU: | MS4120F1006 |
Compare at: | $911.97 |
You Save: | 24% |
Honeywell Damper Actuator, Spring Return , Fast-Acting , Two-Position, 175 lb-in (20 Nm), 120 Vac, for Fire and Smoke Dampers. These Fast-Acting, Two-Position Actuators are line volt (120V), 80 lb-in., spring return direct coupled actuators (DCA) for Fire and Smoke dampers (on/off control). The actuator accepts an on/off signal from a single-pole, single-throw (SPST) controller. Reversible mounting allows actuator to be used for either clockwise (cw) or counterclockwise (ccw) spring rotation.
Features:
80 lb-in. (5.9 N•m) minimum driving torque at 350 F (176 C)
Reversible mounting facilitates use in either clockwise (cw) or counterclockwise (ccw) spring rotation
Integral spring return ensures level of return torque
Fifteen-second spring return timing
No special cycling required during long-term holding
No audible noise during holding
Patent pending design eliminates need for limit switches to reduce power consumption
Models available for 24, 120, and 230 Vac
Ninety-five degree angle of rotation
Actuator holds rated torque at reduced power level
Die-cast aluminum housing
Housing design allows flush mounting to damper
Designed to operate reliably in smoke control systems requiring Underwriter’s Laboratories Inc. UL555S ratings up to 350 F
Includes Two integral 3/8 in. flexible conduit connections as well as a Self-centering shaft adapter, 3mm crank
Product Specifications
Maximum Stall-- 425 lb-in.; Minimum Driving at 350 F-- 175 lb-in | |
Maximum Stall-- 48 Nm; Minimum Driving at 175 C-- 20 Nm | |
-40 C to +55 C | |
-40 F to +130 F | |
89/336/ECC, 73/23/EEC | |
Two position; Single Pull, Single Throw | |
N314 | |
10.67 in high x 3.94 in wide x 2.95 in deep | |
271 mm high x 100 mm wide x 75 mm deep | |
40 in | |
1 m | |
NEMA 2; IP54 | |
Spring Return | |
60 Hz | |
Manual crank | |
Driving (dB(A) @ 1m)-- 70; Holding (dB(A) @ 1m)-- 20 (no audible noise) | |
Direct Coupled | |
5 to 95% RH, non-condensing | |
Driving-- 0.35A, 35W, Holding-- 0.15A, 10W | |
Self-centering clamping | |
3/8 to 1.06 in. round or 3/8 to 11/16 in. square | |
10 to 27 mm round or 10 to 18 mm square | |
By orientation | |
Maximum-- 15 sec | |
175 lb-in. | |
20 Nm | |
95 ±3 degrees | |
120 Vac ±10% | |
Driving @ 60 Hz (sec)-- 15 sec | |
175 lb-in | |
20 Nm | |
cUL C22.2 No. 24-93 |
Product Downloads
Installation Instructions
Product Specifications